And with so many parts to be printed and each with unique setup, make it more complicated, no wonder they sell the 3D printed kits so expensive, because there are so much work to do to prepare it. I finally found out that Blender is not a good choice to make 3D model for 3D printed flying model, so the result is jaggy and not smooth enough and also not optimized. It's just basically 3D printing parts without any optimization for flying model. I am still learning to make 3D model parts for RC model plane and the result is far from what I aimed to be. This model is also an experiment to build an RC plane using 2 different materials together, which are 3D printed parts and depron foam or foam board. This DIY Beaver model RC plane was built solely as a test bed for a brushless motor, esc and prop that sponsored by T-motor. Written by: Julius Perdana Category: RC Foam Project DHC-2 Beaver RC Plane with 3D Printed Parts and Foamboard plans
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |